asdasdasd
My GND Ways Are Gone After Copper Area!!
This time i connected my PCB without Auto Router and after connecting everything i used Copper Area. All my GND traces are gone now. I used H1 as a SMD Header, and i only used 2 pins of it because i want to give 12V to the left pin and GND to the right pin. So only 2 pins will be useful for my battery connection to header, the other pins won't be used. My circuit is only SMD components circuit and also only "Top Layer", so why my GND traces have disappeared after Copper Area operation? What should i do now? Here comes my PCB Layouts without and with Copper Area: #PCB#
Ahmet.Aksoy 2019-03-24 14:01:47 comment 6 0 Circuit Design
My First PCB Layout - Need Support
I am really a beginner and frankly, have no idea about "lots" of things. However, i followed a project and drew a schematic according to it. I believe, my circuit schematic is okay, except i am not sure the MBR2045 connection which i posted in another topic, however i really don't understand much about PCB circuits. I said convert to PCB and then made the Auto Route operation. Yet i am still not sure if everything is okay, if you can check my PCB to see if there is an "open wrong" and even advice me about PCB layouts i would be more than happy. Here are the photos of real project, schematic and PCB layout, respectively: #PCB#
Ahmet.Aksoy 2019-03-20 19:14:36 comment 11 0 Circuit Design
MBR2045 Connection Problem
I really need help about it. I have tried to find information through datasheets but they seem to have only information about the pins, not the connection. I need to use MBR2045 Schottky Diode in my circuit, however i am not sure how to make the connection. I connected 2 pins to each other, and made it like 1 pin and connected it to ground. Is this a correct way of connection for Schottky Diode or am i doing it wrong? Here is the photo of my schematic and the component is symbolised with D1, it is MBR2045CD: #Schematic#
Ahmet.Aksoy 2019-03-20 19:07:22 comment 12 0 Circuit Design
Schematic Component Problems - Need Some Help
Hello everyone :) I am new to easyEDA and i am trying to draw schematic of the project above, which i will need to convert to PCB and also implement in real life. Of course i have lots of questions, which i would be appreciated if any of you can answer: 1) I couldnt find 12V DC battery, am i missing it? 2) In the project above, there is a 15 ohm 2 watt resistor, i couldn't find it so, i used Metal Oxide Film Resistor instead. Can it cause any problems for me? 3) I couldn't find 0.15 ohm 1 watt resistor, all i could find was a 0.15 ohm resistor without any info about watt. Am i missing it too? Or should i just use 0.15 ohm resistor regardless of watt? 4) MBR2045 in above circuit has only 2 pins. But in easyEDA i couldn't find it so i put the MBR2045FCT, which has 3 pins. Should i only connect one of them or should i connect the 2 pins together like in below schematic? 5) In the above project it warns about 1W White LED and i tried to find the most suitable LED. I could find the one in below, its power dissipation is 0.9W. Is this LED appropriate? My easyEDA schematic, for now: #Schematic#
Ahmet.Aksoy 2019-03-04 13:18:08 comment 5 0 Circuit Design