asdasdasd
Can't selecting more pads converted from Multi-Layer to Top Layer
When pads is converted from Multi-Layer to Top Layer then I can't select more (converted)pads with CTRL key. Then I must select pads one by one. When pad is oryginal on top-leyer then no problem with selecting. #BugReports#
Arkadiusz Wernicki 2020-05-15 07:22:10 comment 0 0 Bug Reports
Footprint refreshing after change layer (v.6.3.43)
When I change pad from "Top layer" to "Multi-Layer" then pad is visible in version "Top Layer". When i close pcb editor and load then pad is visible corectly as Multi-Layer. But, when i change pad from Multi-Layer -> Top -> Bottom -> Multi-Layer, then pad is visible correctly as Multi-Layer. Change from Top to Multi is not refresing corrctly. Change from Bottom to Multi is correctly. #BugReports#
Arkadiusz Wernicki 2020-05-15 07:13:38 comment 3 0 Bug Reports