asdasdasd
Rat lines look wrong
Hi! I added a potentiometer to my schematic. I think the rat lines are showing incorrectly. Here's the section of the schematic Here's how the rat lines look on the PCB There are a couple of problems: 1. The rat lines show that the wiper and the other pot terminal should be connected to the same op amp pin (unlike in the schematic\, where the wiper connects to a 220k resistor). 2. The rat lines indicate that the op amp pin should connect to the +ve terminal of the electrolytic capacitor (which it already does). The footprint of the pot is TRIMPOT-PTH-3386U. I've tried dragging the schematic component of that around in the Footprint Manager, just to check it's been drawn correctly The same thing happens if I use a different potentiometer (POTENTIOMETERS_PADS_SMALL). A very similar thing happened when I inserted a three pin header between two diodes which were previously in series. The rat lines do something odd, and the existing nets seems to be broken By the way, huge thanks for continuing to provide and support this awesome tool. Kind regards, Bill #PCB#
Billygoat 2022-09-06 12:15:19 comment 6 0 Circuit Design
A way to join traces on different nets?
Hi, I want to lay some wiring out on my board (see blow) and be able to copy chunks of it *before* connecting to the associated components. It's for capacitive touch sensors. The problem comes when I try to connect the wires. Would I be correct in thinking that this post essentially means "you can't"? Could a way be developed to override the logic that says "these are separate nets - you can't join them"? I've encountered the same issue when doing more conventional wiring: I'll delete the bits I don't like, then try to reconstruct them better, but sometimes they won't join. Or if I try to construct one end of a trace starting at one component, then construct the other end starting from the other component. I'm sorry I'm a bit vague on these more conventional scenarios because it was a few weeks since I last came across it. Thanks #FeatureRequests#
Billygoat 2021-09-17 13:07:46 comment 4 0 Feature Requests