asdasdasd
Help needed with NRF24 reference design
Hi, I had a question about one of my earlier PCB design based on the NRF24L01+ wireless transceiver. This was a correct schematic, but the PCB design was not 'reference' and did not give a good signal, it was noisy and had dropouts. Based on feedback on this forum I concluded I best go with a reference design from the manufacturer. I have now done that and got some boards made. The layout is pretty much exact what the manufacturer recommends, but now I do not get any signal at all, but the chip does initialize properly. Any ideas on how to troubleshoot this? Here is my pcb design, and below I'll paste the manufacturer reference design. I have been reading up a bit about antenna design and fro what I gather the single ended antenna should be more forgiving than a MIFA (which I had before). I'm kinda stumped on where to go from here... Tia for any guidance on troubleshooting. #PCB#
Bob Kruijer 2021-03-21 14:54:09 comment 21 0 Circuit Design
PCB antenna trace impedance
I have been using these 2.4ghz transmitter previously in my arduino projects, with good success. One of my latest PCB design incorporates the schematic of the chip used on these boards. It is working but I've narrowed an issue down to the pcb antenna, and the manufacturing of that. Basically I'm having intermittent signal loss and other weak signal artefacts. My question is, knowing that certain factors of the radio signal and the 'ideal' antenna will depend on the final casing and other components, how do I make sure I can get the trace impedance to be 50 ohms? THis is required by the chip manufacturer. Assuming the microstrip impedance is the way to calculate this (I used this one https://www.eeweb.com/tools/microstrip-impedance) for a 'standard' board, 1.6mm thickness, 1oz trace thickness and substrate dielectric of 4 (which I believe is FR4) I get a trace thickness of 3.2mm. However, the PCB on most of these off the shelf transmitters (they are around 1-1.1mm thick) have antenna traces of 1mm width. I am puzzled as to which is wrong here. Based on the info that I know, should I go with the 3.2 mm wide trace antenna? Or should I rather 'copy' the layout of these existing boards, even though I cannot know the trace thickness and thus my information to calculate their exact impedance is incomplete? #PCB#
Bob Kruijer 2020-03-23 21:30:37 comment 21 0 Circuit Design