Help With Multiple ST Microelectronics VL6180X
Hi there, I'm looking for some help in designing a PCB that houses multiple inline ST Microelectronics VL6180X sensors. I've tried several iterations in an attempt to reduce the footprint to the smallest size possible: The first version was based off of the Adafruit VL6180X breakout board. This iteration was broken into two boards. The top board only houses the sensors on top with a set of male header pins on the bottom. The bottom board houses all of the components from the Adafruit breakout board in which the board is double-sided. When attached to an Arduino, the software always fails to initialize the last sensor in the string, regarless of how many sensors I am attempting to initialize (the software works for an array of Adafruit breakout boards). The second version was based off of this project that I found on the Hackaday website (https://hackaday.io/project/163920-a-halo-for-lucy/log/162154-the-second-pass-prototype) in which the author used the VL53L0X sensor (similar to the VL6180X). This is the schematic that was used in the author's project vs. the schmatic that I used for my own project. I've found an application note from ST Microelectronics (https://www.st.com/resource/en/application_note/an4478-using-multiple-vl6180xs-in-a-single-design-stmicroelectronics.pdf) that offers this schematic detailing how to add more than one sensor to the same board: Note: The GPIO pins referenced in figure 3 are the same as the XSHUT pins in my schematic. Instead of the GPIO expander, the sensors are connected directly to an arduino Mega 2560. Could anyone tell me how far off I am in my design/point me in the right direction? Any help would be much appreciated - thank you! #PCB#
Does a BOM for the Arduino Mega 2560 Exist (That is Known to Work)?
Hi, I'm working on a project based on the Arduino Mega 2560. I've now gone through 6 iterations of the prototype but the current issue that I'm facing is that there is a communication issue with the RX and TX pins (perhaps because I've used the wrong part somewhere). I'm wondering if there is a BOM for the Arduino Mega 2560 that is known to work that I'm just not finding. I feel like I've looked up and down the forum and I've come up with nothing. Any help would be greatly appreciated. Thank you. #GeneralDiscuss#
Parts too small to be soldered?
I submitted my design and received a response saying: "As shown below, there are some parts which package is small, all, and we cannot solder it. Thus, we won't solder it, ok?" No, it's not ok. I'm using a PCB manufacturer because I can't solder SMD parts myself... "Can we just make it as shown in the picture?" I thought that that was what I was asking for when I submitted my gerber file, but apparently there's a difference?... I then asked "Can you tell me what 'package is small means' and how I go about fixing this?" to which the response I received was "The package is small means that the size of the part is small." Ok, now that have my answer this raises some new questions that I hope someone here can shed some light on. 1. Is the part too small to be soldered\, or is there some other possible problem? For instance\, a track or via that is too close to a segment of the part. 2. If there are in fact parts that are too small to be soldered\, why are these even available in JLC's parts catalogue? Can anyone suggest a possible fix for this? Do I need to find "larger" parts to replace the "small" parts? Thanks in advance for any help. #PCB#