Place square hole in PCB
What tool would you use in EASYEDA to place a square or rectangle hole in the PCB? #PCB#
Removed
How does one delete a post? #Schematic#
Auto router seems to be on the frits
Seems to be an issue with the version of EasyEDA for Mac OSX I'm running or it's corrupted software on my iMac. I'm not able to update to latest EasyEDA version 6.4.17 while running Mojave. Does version 6.4.17 still work? If just corrupted can that version still be found? Down to my last PCB out of 6 to auto route and all went South. Last PCB routes about 7 track but then stops at 0% Auto Router mode. Restarted my iMac, no help. Took another PCB that had been routed and tried to re-route it and the same. ?????? Has anyone else been able to auto route today? #PCB#
Cutouts
Are the cutouts located next to the edge connector cut out by JLCPCB when manufactured? #PCB#
Replacing component
If I have laid out a PCB and it's been routed what is the best way to replace a component like a resistor with one with a slightly different footprint? I have made the change to schematic but run into problems with traces after importing changes to the PCB. #PCB#
Via Diameter DRC Error
After adding a few traces and a few Via's I see DRC errors for Via diameter. Both layer traces seem to be connected with the Via. What might I need to look for to correct this? #PCB#
Clearance Issues
After replacing several resistors to accommodate a different footprint, I ended up with clearance DRC issues that I cannot clear. I imported the changes in the schematic to the PCB, deleted the old resistors, and placed the new ones. Is there a step I'm missing? There are actually no clearance problems on the PCB. #PCB#
Remove unwanted 3D footprint
I placed an LM324N IC in my schematic. When I converted to PCB a 3D footprint with no connections also showed up along with the normal footprint. Not knowing what I was to do with this extra footprint I attempted to completely remove the IC from my schematic and start over. Although the LM324N has been removed the 3D footprint is still added each time I convert to PCB. Two questions; what was I supposedly to do with this extra footprint, and can it be removed? #PCB#
Flipping a 44 pin connector
The connector I need and located in the library has the numbering from left to right 1-22 and on the bottom of the board A-Z. I need to have the lettering on the top of the board Z-A from left to right and 22-1 on the bottom. I'm not understanding how to flip this connector. #PCB#