Want to make a PAD that has a cut out, but only exposed copper on one side.
I have achieved this by placing a board cutout over a pad on the bottom layer. This conflicts with my design rules, but I thought it might not matter. The board in the 2D view looks like this: This is how I want it to look. However I am not sure if the conflicting board cutout and pad is acceptable. After exporting the Gerber and seeing the view in the order page - this view does not show the cut outs at all, is this normal or have I done something wrong? Thanks! #PCB#
Understanding solder mask colours in 2D/3D view compared to PCB Design
Hi, I am trying to design a very simple PCB, I'm very much a learner for Easy EDA and PCB design in general. I basically have a question regarding solder mask. In the 3D view here: There are a few colours, as I understand them: Blue: Solder mask Light Yellow: Also Solder mask, but solder mask at the edge of a pad - I don't really understand why this would have a different colour? If I remove the 'solder mask' on a pad, this light yellow are disappears, so I concluded from this it is solder mask - but then the top pad doesn't make sense... Dark yellow/gold: Exposed pad You might have guessed the problem I have, and thats that when I connect two of these exposed pads the light yellow area seems to make its way into the pad - the two pads at the top are connected with a copper area: The PCB isn't finished by any means, I just wanted to understand what I'm seeing, why the larger top pad seems to fill in with what I thought was solder mask, and for some reason the edge of this pad still shows gold/dark yellow. Am. just seeing a bit of a bug or is this behaviour expected? #PCB#
Quick n00b question - using components not stocked by JLCPCB
Hi, So I am just designing a very simple circuit board which will use these Wago connectors: https://www.wago.com/gb/pcb-terminal-blocks-and-pluggable-connectors/smd-pcb-terminal-block/p/2065-100_998-403 They are not in any of the catalogs on EasyEDA or JLCPCB. Is there any way for JLCPCB to make a PCB with these components mounted? It isn't too much of an issue as I go through testing, but if I scale up I was wondering if JLCPCB are the right service. #SMT#