Incorrect DRC clearance rule applied during manual track route
We have been having difficulty manually routing a track between two pads of a 2mm pitch connector even when we set a rule for the net in DRC which should easily allow it to pass through. In our example the rule (My_Rule) is applied to Net G0 for a minimum track width (0.1mm) and clearance (0.1mm). The pad size of the connector is 1.524mm leaving 0.476mm of space to run a track in-between. A 0.1mm track should easily fit without violating the DRC clearance. What we see during the manual route (see below) is a track width representative of a 0.1mm track and its associated boundary, however, we are prevented from passing the track through. If we edit the DRC Default Rule (which is not associated with Net G0) and reduce the clearance to 0.1mm (was set at 0.152mm) we can then pass the track between the pads. It looks like DRC is not applying the clearance setting properly for the particular rule assigned to the net. Q. Are we using the custom rules setting of DRC correctly or does it need to be refreshed somehow to ensure new (or modified rules) are applied ? #PCB#
Abandoning a command in Schematic Capture reinstates all original properties
Note : Topic originally posted under Schematic Capture Being able to abandon an operation (with a single keystroke) and have all modified properties reinstated would be a good feature in Schematic Capture. For example, currently using \ during a component move operation will abandon the command BUT it leaves the components on the screen wherever they happened to be when \ is pressed. The improved behaviour would be for \ to abandon the move operation AND for the components to move back to where they were prior to the move. This improved behaviour would more closely replicate how lots of other software behaves when \ is pressed i.e. it reinstates the original properties. It would also reduce the number of keystrokes during schematic capture. The behaviour could be extended to other operations. #FeatureRequests#