asdasdasd
Delete a schema
Hi, How is it possible to delete a schema from a given project? I see the button for deleting an entire project, but I can't figure out how to remove a single schematic file? Thanks in advance #Schematic#
Eusebius 2016-09-09 07:25:14 comment 2 0 Circuit Design
Waveform not displayed after transient simulation
Hi, this is a SPICE newbie question. I used a non-inverter amplifier circuit (with LM741) to play with SPICE simulation in EasyEDA: https://easyeda.com/editor#id=7mIC8NHBT When I launch a transient sim (be it with a 1V DC input or with a sine), I'm quite happy with the initial conditions shown in the results (at least regarding the nodes I have named myself), I'm reasonably happy with the 1012 data rows it claims, but I'm a bit frustrated by the absence of a waveform. What have I done wrong this time? My simulation results (1V DC input): Circuit: untitled Reducing trtol to 1 for xspice 'A' devices Doing analysis at TEMP = 27.000000 and TNOM = 27.000000 Initial Transient Solution -------------------------- Node Voltage ---- ------- xu2.11 14.9602 xu2.12 14.9601 xu2.6 -0.000858624 xu2.7 11.7991 vs 9.99926 xu2.53 12.4 xu2.54 -12.4 xu2.90 11.9991 xu2.91 25 xu2.92 -25 -vee -15 vcc 15 xu2.99 0 xu2.10 0.402537 v- 0.99989 xu2.13 0.416472 v+ 0.99996 xu2.14 0.416497 xu2.9 0 xu2.8 11.7991 e 1 h.xu2.hlim#branch-2.39982e-11v.xu2.vlim#branch 0.0119991 v1#branch-8.02178e-08v3#branch -0.00166656 v4#branch-0.0016667v.xu2.vln#branch -3.69999e-11 v.xu2.vlp#branch-1.30017e-11v.xu2.ve#branch 2.24001e-11 v.xu2.vc#branch2.40154e-12v.xu2.vb#branch -8.58624e-09 a$poly$e.xu2.egnd#branch_1_0 -0.0119991 No. of Data Rows : 1008 ngspice-26 done Thanks in advance. #Simulation#
Eusebius 2016-09-09 03:42:55 comment 3 0 Circuit Design
Newbie: simulating a simple DC circuit
Hi, I'm just testing EasyEDA and its simulation feature. I'm clearly not fluent in SPICE, but I've read the introduction page about how to use it in EasyEDA and it seemed clear enough to me. However, I just can't manage to run a simulation on the simplest circuit ever (battery + resistor, just probing VCC and GND). When I try to run a transient or DC operation point sim, I end up with a "Error: no such vector 0" message. Also, in the transient analysis results, I don't understand why the second value is labelled "v1#branch" and not gnd, for instance. Circuit is here: https://easyeda.com/editor#id=7mIC8NHBT If anyone had time for beginner issues, it would be appreciated! #Simulation#
Eusebius 2016-09-08 05:08:42 comment 4 0 Circuit Design