asdasdasd
Hole size tolerance for Holtites
I have some cases where I'd like to use Holtites, which are intended to press fit into plated PCB holes. The problem is that the Holtite manufacturer specifies a tolerance of +/- 0.05mm for the holes (finished size after plating), but the JLCPCB specs are +/- 0.08mm. Is there any way to accommodate this? Typically this would only apply to one hole size (e.g., 1.47mm finished) on a given PCB, if that helps. I believe some people solder Holtites, but that's a bad idea for a couple of reasons, so I'd rather not. https://www.te.com/usa-en/product-6-1437514-8.html Fred Wright #PCB#
Fred Wright 2018-12-20 16:59:48 comment 0 0 PCB
Thermal Relief Pads
Where through-hole components connect to inner planes, it's usually desirable to use thermal relief pads. See, e.g., Thermal relief. Whenever I've had to rework boards without thermal relief, I've found myself cursing the PCB designer, and don't want to have to curse myself. :-) I have two questions: What's the best way to accomplish this in EasyEDA as it is now? Would you consider adding a feature to make this more straightforward? Thanks, Fred Wright #PCB#
Fred Wright 2018-09-26 05:12:48 comment 1 0 Circuit Design