Subckt Library Item #111 is not initialized properly.
The EasyEDA SPICE model and subckt library list (last updated170710 (YYMMDD)) : Sheet1 lists '111 BATTERY_LEADACID_12V_7AH subckt 10-20 18:15'. I created a 'public' circuit 'TestSimA' in my user area. My voltage probes do not display any voltage on the graph. Looking at the 'subckt' it appears the line establishing a 6 cell battery is disabled. I haven't figured out where/how to find this subckt so I can edit it. Concise problem statement: 12 volt 7ah battery is not initialized to 12 volts. Steps to reproduce bug: Load 'TestSimA' from my user area. Run the document. A graph is generated, with two voltage identifiers, but the voltages are zero! Results: The battery is 'DEAD' (improperly initialized). Expected results: 12VDC available to power the circuit simulation. Voltage curves should be displayed on the graph. Browser: Latest Chrome #BugReports#
Simulation Help
I think I used the "555" that has a Spice model. I really didn't understand how to check, but "555" is listed in the document. I have "555 Sine Wave Generator" as a Public Project. I want to use a 555 to generate a 1Hz square wave. I think I'm close but I can't get volProbe* recognized by the simulator. I calculated RC values for a low pass filter of 10K and 1uF with a filter cutoff of 15Hz. Desired output: 1hZ output Sine Wave. Questions: How do I "offset" the filter output to be zero based with a 1.0V amplitude? In this case, I need to drop the sine wave so it starts at 0VDC and has a 1.0V amplitude. Why won't the volt probe work in the simulation? I've tried different labels; no go. Thanks, from a beginner! #Simulation#
Help with simple circuit
Help me! I'm an noob and I can't solve this! I have a screw type terminal block, a resistor, and a led in the schematic. I have tried netlabels, netports, and +5V/GND and can not get the PCB to have the correct wiring. If I use the PCB tool and add the airwires, it will autoroute. If I make a change and update the PCB, the airwires get erased and the autorouter goes to 99% and hangs. It looks like the netlist is incomplete. What am I doing wrong? 'DRC_Errors' is my Public 'project'. TIA Garry #PCB#