asdasdasd
Soldering components from both sides of two layer PCB
Hi, I'm creating PCB for transmitter and would like to know whether it is possible to place all components on one side of the two layer PCB except for 2pin header to which I want to connect battery? The PCB has GND copper pour on the top side where most of the components are placed and VCC copper pour on the bottom where I want to place the header. #GeneralDiscuss#
Hana Šustrová 2020-10-15 19:56:56 comment 2 0 Others
Thickness of wires
Hi, I'm trying to build an RC car and I'm creating 2 PCBs in EasyEDA for this project, but I'm not sure how thick should be the wires. Here are my PCBs: https://easyeda.com/sustrovah/rccar (https://easyeda.com/editor#id=41a205d0869c4a96a0471da4a487e25d) https://easyeda.com/sustrovah/rccar2 (https://easyeda.com/editor#id=41ac601433f4435a9a63c707e7599cc5) Thanks for help in advance #PCB#
Hana Šustrová 2020-10-03 04:20:28 comment 4 0 Circuit Design
transmitter
Hi, I'm a beginner to creating PCBs and I'm not sure, whether the thickness of the wires and the way I connected everything is right. My plan is to make an RC car using Arduino and the NRF24L01 wifi modul. I would appreciate anyone to look at my PCB and check it. Thanks in advance https://easyeda.com/sustrovah/rccar https://easyeda.com/editor#id=|dec8715176d44ff2882fa9664e25b015|41a205d0869c4a96a0471da4a487e25d #PCB#
Hana Šustrová 2020-09-26 02:39:13 comment 17 0 Circuit Design
connecting GND
Hi, I'm creating my first PCB and was wondering if it's okay when all of the GNDs are connected together. #PCB#
Hana Šustrová 2020-09-23 05:05:36 comment 3 0 Circuit Design
GND and VCC symbols
Hi everyone, I've been trying to make schematic and PCB design for my RC car project, but I don't know how to make the pads for ground and VCC whicht I would like to connect to batteries later. When I place the GND and VCC symbols to the schematic and then convert it to PCB there isn't any of these two pads. Thanks for response in advance #Schematic#
Hana Šustrová 2020-09-06 23:38:49 comment 2 0 Circuit Design