asdasdasd
Net incomplete??
Hello, I have noticed that some of my net connections are incomplete. I am however concerned about my PGND net in the PCB layout found here: https://easyeda.com/modules/Final-base-model-copy_97c02445bed64e0a921208617a7d53d8 . I cant seem to find where the missing net connection is so is this a bug?? Thanks, Ibrahim #BugReports#
Ibrahim Qasim 2020-11-12 15:33:07 comment 4 0 Bug Reports
PCB high current thermal design
Hello, I was looking to implement thermal vias to reduce heat on my LiPo battery charging PCB. It should allow for up to 2.5 A and I've already ordered previous versions of the board that would cause my main battery charging IC to go into thermal shutdown. Is it possible to take a look at my PCB layout/design to make sure my traces are wide enough and vias are placed properly to ventilate heat?? Here is the link to my project page: https://easyeda.com/iqasi096/bq24650evm-board_copy Thank you! #PCB#
Ibrahim Qasim 2020-08-31 15:13:57 comment 17 0 Circuit Design
Part number C134092 help
Hello, I was looking to use this female receptacle to charge my lipo battery via a mcp 73831 chip, is there a way to ensure it stays as an input and not an output potentially damaging my power source? Also, I put together a design to test my theory and it has been charging at a reduced rate than expected, are there any other pins I should be utilizing other than the VBUS and GND pins to ensure maximum utilization of the product? Thank you #GeneralDiscuss#
Ibrahim Qasim 2020-05-18 21:24:50 comment 1 0 Technical Discussion
Part number C134092 help
Hello, I was looking to use this female receptacle as an input into a MCP 73831 chip to charge my lipo battery. Is there a way to ensure this continues to act as an input and not as an output which can potentially damage my power source. Also, I have implemented a design for it such that it charges my battery, it does however charge it at a slower rate than expected. Are there any pins I should be using other than the VBUS and GND ones that I should be utilizing on this part? Thank you. #GeneralDiscuss#
Ibrahim Qasim 2020-05-18 21:22:05 comment 1 0 Technical Discussion