asdasdasd
Working with multiple designs on one panel
Hi all So I'm working with these two layout in one panel design: Now my question is can I just send this to JLC and they will copy the existing two designs onto the last two PCB's when I tell them that there are two designs? Also I noticed that JLC wants tooling strips on all four edges for round PCB's but I can only define them for two sides not four. How would I solve this? Do I need to manually panelize this? I Also noticed that copper areas don't work outside of the original design. (That's why the second design has a weird layout) Are there any further remarks about panelization? #PCB#
JFK422 2021-03-21 00:36:02 comment 0 0 Circuit Design
DRC Clearance Issues despite having defined a low enough value in the DRC
Hi All So I stumbled upon this issue that I get a DRC clearance error despite having defined a lower clearance value in the DRC. This issue arises from the pads to vias and form the pads to pads. It happens with every package below 0.3mm. I tried replacing some packages with similar ones. Thou the same issue. #BugReports#
JFK422 2019-11-29 05:11:14 comment 1 0 Bug Reports
Cannot place track length tuned trace
Hi I tried to tune the track length on a parallel bus of mine. The issue is as soon as I try to place down the tuned track, it doesnt apply the new trace. There is no other trace to block its path and no conflict with the drc. Thanks for looking into it #BugReports#
JFK422 2019-09-17 13:35:31 comment 3 0 Bug Reports