asdasdasd
Auto Routing Issues
Hello, I'm having some issues with Auto Routing. The connections look OK on the schematic. I can update the PCB and Rat Lines are there but after the Auto Routing there's no connection. Seems to be happening for quite a few traces. Regards, Jared #PCB#
Jared Kondratuk 2021-06-06 06:31:46 comment 8 0 Circuit Design
Update/replace connector on existing layout.
Hello, I placed several 50 pin headers on a board. Used a user contributed part. Received the board and the actual connector doesn't fit. The row to row spacing is correct (2.54mm) but the spacing between the 2 rows is greater than that and the connector won't fit. Is it possible to just insert/replace the current connetcor part with the correct one? Or do I have to do a new layout? Regards, Jared #PCB#
Jared Kondratuk 2021-06-02 09:07:05 comment 8 0 Circuit Design
Connector Connection
Hello, I've been working on a very simple transition board that has a couple 50 pin IDC Headers and some wire pads. Tried autorouting several times and it didn't work very well. It was making connection that were not connected and then not making some at all. So started manual routing. I guess I'm not sure it's making a trace connection to the 50 pin header. It looks like the trace is connecting when making it but after when I hover over the trace the trace and pad light up but the pin on the header does not. Does something have to be done to the connector to make it connectable? Connector was from the user contributed library: S-50M-2.54-5. Regards, Jared #PCB#
Jared Kondratuk 2021-05-18 07:03:29 comment 3 0 Circuit Design