Questions from a first timer
I am attempting my first PCB and not sure if what I produced is missing anything obvious. The concept is a female header connected to a PCB that will route those connections to plated holes where I can use an alligator clips. Here is an example of what I am hoping the circular plated connectors would resemble: https://www.adafruit.com/product/3333 And here is what I have created: https://easyeda.com/amazingjoe/copperbreakout Questions: Do I have everything in place (solder pads?) that I would need to solder the female header? Is this right putting the traces on the top layer and soldering on the bottom layer (to attach the female header)? What is generally best practice for placement of traces? In the example the holes have copper plating around them and also to the edge. Is that a copper pour or is it called something else? I can probably figure it our with some Googling if I know what it is called. If there are any super obvious flaws (other than the trace lines / through holes being a bit uneven) please share. Should this be a single layer PCB or does it need to be 2 layer to have the soldering pads on the bottom layer. (Do I have anything on the bottom layer (pads)? It looks like I do when I view the Gerber visualization) Thank you for the time you spent reading this post and any feedback provided. #PCB#