Spacing for fuse holders
Trying to get the spacing for these fuse holders down so i can stack them, but i can't see the outline properly in the PCB layout. Can anyone give me some help to get them spaced properly so theyll stack? #PCB#
Board not routing entirely
As you can see, the J2 and J3 are only half routing. I've tried just routing those to the IC and it regardless of what i have it will only route half of the screw terminals pins. I've tried deleting and re-adding in the schematic and still it wont route it when i click route. I'm at my wits end, any help would be appreciated. #PCB#
Cannot figure out how to correct this problem
I've used the help prompt that pops up with this error, and i cannot figure out how to do either of the solutions. Solution one, Change the schematic symbol. Using PinMap function. Change the PCB PIN from C to K. And save your schematic again. Solution Two, Modify the Footprint. Edit the Footprint, change the PAD from K to C. So, we should aware that PIN number should be the same as Pad number. When i try to do either of these i can't find my specific PCB PIN to change or PAD to change. How do I get to these menus to change it so the error goes away? #PCB#
what are these resistors for in mega schematic?
I am just learning how to use EasyEDA, reading schematics etc, but this has stumped me. I'm not sure what the highlighted resistors in the picture above are for. I've tried to find if there are connects labeled 2 and 7 that they would connect to and I cant for the life of me figure out what they are for. #Schematic#