asdasdasd
CD4027E Simulation
CD4027 Dual Master-Slave J-K Flip flop has been around a long time. Found its schematic symbol OK, and put in circuit. Attempts at running simulation fail, something about lacking a spice simulation module. How do I get a spice simulation module for this chip, and how do I insert it into easyEDA ? I've seen others with same problem, I under stood them to say such a simulation module is not in the CD4000.lib, but I don't know how to add that libary to my easyEDA libraries evwn if it is. Below is schematic, I realize their may be error there in, such as resistor values etc., but the problem prompting this post is no spice simulation seems to be available for this chip. #Simulation#
K0DPW 2021-07-07 05:49:46 comment 3 0 Circuit Design
Pre Designed PCB into EasyEDA
What is best way to enter a pre-designed PCB into EasyEDA from an image in magazine. I have tried two methods, each has problems. 1) Captured magazine image into Inkscape, then did a bitmap trace to get borders of circuit traces, then saved Inkscape bitmap trace to .dxf format, then imported .dxf into EasyEDA. This got perfect reproduction of PCB, but copper traces are blank - since they are irregular patterns, using copper fill is next to impossible. EasyEDA needs a fill feature, similar to the fill feature of MS Paint, where areas can be filled in up to a boundry - if this exists in EasyEDA, I can't find how to do it - only able to create areas with relatively straight lines, etc. using "copper areas". 2) Imported into EasyEDA PCB canvas the pre-designed PCB as an image. This got excellent reproduction of original PCB, including copper traces / areas filled in. But when I try to make drill holes for component leads or mounting holes, they do not attach to the image, and therefore when image is moved, holes do not stay with image. I assume the same would happen if entering text, etc. onto the image. #Skill#
K0DPW 2017-07-30 04:17:03 comment 2 0 Circuit Design