AREA for no copper/tracks
Is there a way to create an area that won't have any copper or track? Ie avoid an area on Auto route Not cover with a copper area? #PCB#
Copper Layer - Auto Router
Hi First time using the copper layer, I've drawn a copper layer for the bottom of my PCB and set it to GND. I Can see it has connected all my ground connections. However, Auto Router is still making GND tracks on the top of my board. How do I solve this? Kev #PCB#
Updating a board after importing from standard
Trying to update a PCB for a project which I imported from the standard version. Get an area message which doesn't make any sense and has really bad spelling and grammar. #PCB#
GND Tracks. Linking two, different trace sizes
Hi. So I have a PCB that has two circuits. One Side has a wemos D1 powered by power supply A. It is used for decoding data for WS2811 pixels. The second side has some fuses that power the pixels PIXELS from Power Supply B. The Tracks on side for power are 4mm.. I'm using net GND1. For the side powering the wemos I just want the default width. Called GND I need to link the GND of the two circuits, maintaining the 4mm for the power side and default for the wemos. How do I achieve it? #Schematic#
Flip pins - wt32
Hello. I'm a using a wt32-eth01, i need to insert the module upside down into my pcb. How do I flip the layout over? #PCB#
header pins for wemos d1
Hello. So I'm using the symbol for a wemos D1, on the PCB layout it place the holes correctly. But how do I add the header to the PCB? Kev #PCB#
Converting Tube Schematic to PCB
So I'm using a 12au7 symbol. The 12au7 physically is a dual-triode, I have two symbols one for each triode. This helps me look at the circuit. I now need to connect them together, I've routed pin 123 on the symbol to 678, but still too items on the PCB.. The 12au7 also has a heater on 4 and 5. Can I do this? Kev #PCB#
Trying to make a 12au7/tube simulator work.
Hi All, Sorry for filling up the forum with questions - steep learning curve. I like breadboarding with 12au7 tubes, there a DIY project called Valve Caster.. and it works. I've built the simulation, imported two spice modules for the 12au7.. 1v goes in 0v comes out. Here the project https://easyeda.com/editor#id=|c054c0dc1818473ea988410bcaf9ef60 I would really appreciate some help in making this work. Kevin #Simulation#
Importing Spice models for simulations - Tubes
Hi, Hobbyist here, need some "idiot guide" I inserted a 12AU7 tube. I clicked Spice Lib and found a 12au7 "user contributed" I built my schematic and ran the simulation. I then get a warning saying some parts don't have spice models.. Its says i can assign one.. How do I move forward on this... #Simulation#
Running a simulation - variable resistors
So I've built a tone circuit using variable resistors. When I run the simulation I get this error: The simulations has components without a simulation model:r250k_3 What am I doing wrong? Further to this - I cant seem to find where I change the simulation settings. I'm trying to see how the circuit affects the frequency response of an audio signal. Totally new to easy eda, appreciate any help Thanks kev #GeneralDiscuss#