PAD thermals, how to change spoke width.
How can I change the spoke size on grounded pad thermals 73 Kees K5BCQ #PCB#
Rectangular holes
How do you insert rectangular holes in the board #PCB#
Error "Decompress failed"
I just received a "Decompress failed" error message on one of my physical designs. Is there a way of recovering to the previous physical design ? I do have earlier designs but there were many changes made between the two, which I would have to make again. #BugReports#
Canvas origin coordinates
When I change the canvas origin coordinates of a given design the physical data changes correctly but after doing a "save" and recalling tthe board information the original coordinates come up again.. #PCB#
Board Layout coordinates
Typically when I do the physical design, the upper left hand coordinates start out at -500 and -500 with the 0,0 coordinates near the top left hand of the screen. I have one board which starts out at -19,500 and -14,500 after the cat walked across the keyboard. That takes a lot of scrolling to get back to -500 and -500 and my board layout. How do I correct this ? The cat won't tell me what she did. #PCB#
0,0 coordinates
Most of the designs I have come up with the physical layout close to 0,0 ...I apparently did something on one project to change the "start" location to -20,000, -14,500. How do I put it back to 0,0 ? #PCB#
Combining orders for DHL shipment
I want to fabricate boards from 2 different projects in 2 different groups/teams but have them placed as one order. #PCB#
Arduino Nano 3.0 Logical and Physical
I can find several Arduino Nano 3.0 libraries and used one for my schematic. I can't seem to find a physical library or a 2x15 pin arrangement, or even a 1x15 pin arrangement with 2.54mm pin spacing. #Schematic#