Square holes on the PCB?
Hello, I wonder if it is possible to make a square hole on a PCB within EasyEda? I have tried most of the tools but havent been able to make a square hole. The only thing I can think of is to use the board outline tool, but then I am unsure how JLC would handle that... Just want to ask first so I dont miss anything simple, orelse I'll just try the board outline tool and make an order... :) #PCB#
solder pads as "jumper" how to, soldermask, etc...
So I have seen before and had an idea of using SMD soldering pads close to each other as "jumpers" (see image). Meaning that I just put a small dab of solder on these two pads and that is the jumper. I did a testrun of PCBs and when I tried to solder them together, I had to slab on soooo much solder for them to connect. The pads seem to be very well Isolated from each other and this is ofcourse a very good thing usually so no shorts will happen by mistake. But in my use case I WANT them to "short"... Could I resolve this by changing the soldermask, so the area inbetween the pads are within the masking, and that would somehow make it easier for the solder paste to "stick"? I would just like some ideas before I fix/try and order a new batch... Thanks in advance, #PCB#