asdasdasd
Lost files
I was sent a new modem by my net provider. So I have reloaded EasyEDA but now all of my 33 projects sch's and PCB's are gone from EasyEDA. How do I get them back? If helpful when I say open, it opens my windows explorer but my work is in the cloud not my comp. #PCB#
Laurie54 2023-07-17 19:08:34 comment 5 0 Circuit Design
Generating a CPL file for JLPCB
I need to have JLPCB place and solder 2 of USB-3 female connectors on the brd. JLPLCB says EASYEDA can tell how to produce a CPL file to accomlish this. Could you please show me how? #SMT#
Laurie54 2022-12-29 14:33:29 comment 9 0 SMT Components
Sch symbles and PCB symbles
I am drawing a sch of a cct from the net. It uses 2 of a TL082. That is 4 op-amps. I found the symbles in sch and added them in. But it will not convert to pcb as there is no PCB footprints. Sinse then I have tried brining in from digikey but the sch symbles is not 4 op-amps but one box symble. I have also tried using other op-amps but I can't find one that has sch symbles and PCB symbles. I also tried (using the pcb footprint manager) and selected the sch symble with an SOIC footprint. It even added the ratlines in to the proper connections on each. Then when I left the footprint manager it deleted the sch and pcb footprint altogether. I'm asking what 8-pin soic, dual opamp can I use which has 2 opamp sch symbles and the proper 8 pin SOIC footprint in the PCB editor? #PCB#
Laurie54 2020-08-24 08:33:54 comment 1 0 Circuit Design
Clearance Issuses
I have many clearance issuses on my board in places where there is no parts or foil tracks within 10mm. Deleting ground plains in those areas does not seem to clear the problem. Reading has shown they can be ignored. #PCB#
Laurie54 2019-12-09 12:09:26 comment 1 0 Circuit Design
Net line with no where to go.
I have drawn the sch which has passed all tests and then went to the PCB. I have finished drawing it and all net lines have dosapeared except one line. It does not connect to anything on either end. It is just a blue netline which runs across the top right corner of the board. All connections and parts on the board are connected and acounred for. Will this be a problem when I get a board done? #PCB#
Laurie54 2019-11-15 13:31:26 comment 13 0 Circuit Design
Pin Number error
My first time using EasyEDA and day two into it. Having fun but have found an error in the pin numbering of part MBR0520LT1G. It is a P-ch mos. The gate pin 1 is labled as 2 and the source pin 2 is labled 1. Therefore when building the PCB parts are netlisted to the wrong pins. Do you have any idea where I went wrong? Thank you. Laurie #Schematic#
Laurie54 2019-11-13 20:32:37 comment 5 0 Circuit Design