DRC Errors - Track, Pad Clearance
I have two identical USB2.0 receptacles which show the following errors :Top row, righthand receptacle, bottom row, lefthand receptacle. I have moved the components aside to inspect for stray trace fragments and none exist. Can you suggest a solution? Thanks, Brent May I assume that the Gerber files will show the ground connections (ovals) at the top left and right sides of each component? #PCB#
DRC Net Pin Error
I have a single Net Error and Net Pin Errors associated with each end of this net. Each pin is part of a common footprint and all pins appear to be alike on each IC using high magnification. I see nothing wrong with any segment of the net including lack of any spurious trace fragments at either pin. How can I learn what might be wrong with these pins (which presumably produce the Net Error)? #PCB#
Repositioning Grid
I have completed my PCB design, ready to generate Gerber files. I had placed all components with reference to fiducials related to a centered X=0 / Y=0 axis and fixed them in place. I now find that the center point of my PCB layout has shifted along with the values for each of the fixed-location components. How can I shift the grid back to its original orientation to make the fiducials match those required to match my existing design in another drafting program for the device enclosure? #PCB#
Created Design Rule Disappears
Clearance Errors Question after scanning all 72 pages of Forum entries for an answer: I created my own custom Design Rule which also includes 0.160 tracks, 0.400 vias, 0.200 drill sizes, and 0.100 clearances: all sizes chosen as being proportion to the .254 track and via settings in the default DR and further confirmed in a Forum reference to “capabilities”. Selecting “Apply” to my new design rule I expected clearance problems to disappear which they did not after resizing the tracks and vias manually. I NOW see that after leaving the Design Rule window, returning to it shows that entries for my design rule reverted to the Default despite showing my rule applies to all the nets in my design. I tried re-entering my design rule repeatedly to no avail. So I can’t clear dozens of clearance errors even though the PCB appears to have no clearance issues after resizing manually. Of course now additional errors appear following manual resizing. Thanks for years of assistance. #PCB#
Placing components at discrete angles
I have to position through-hole components at discrete angles (other than 90°). Are the only options to create new footprints for each component or add holes and pads directly into the PCB layout at the required positions? 1) Is it possible to draw original footprints with holes/pads at discrete angles or only at 90°? 2) If adding holes and pads, can I remove a ratline from the original component footprint transferred from the schematic to the PCB layout and manually reconnect them to the newly inserted holes and pads, and then delete the unused original component footprint in the PCB layout? #PCB#
Adapting EDA schematic to imported PCB pin layout DXF file
I have an extremely detailed DXF file pin layout for a circular PCB onto which I want to superimpose and manipulate my schematic. How is this done? #PCB#