asdasdasd
Routing: Choose where the 45 degree angle is placed
Hi, while routing a track with a 45° angle, I want to decide which way the track takes. So either start or end with 45°. I can not find a way to toggle this. In Altium you simply press the spacebar. Pressing L does not do the right thing. In the animation I try to go horizontally from the beginning, but cannot get it to work. The only way is to drag the track after it is placed. This might be ok for little pojects but not if you have to do a lot of routing. I hope somebody can help. Best regards Lukas #PCB#
Luks 2020-03-31 17:38:37 comment 3 0 Circuit Design
How thick is the through-plating of a through hole pad?
Hello, I would like to implement a press-fit contact. The manufacturer describes the requirements of the pad very accurate, as you see below. I want my design to suit the description but I don't know where to set the through-plating thickness. Thanks in advance and best regards, Lukas #PCB#
Luks 2019-01-09 22:24:32 comment 10 0 PCB