asdasdasd
Drc errors with library component
hi i'm new to pcb design. only done electronics for hobby. i tried to design a simple pcb for using TPS63070 from texas instrument , connecting its pads to a male header to use with bredboard easily. so my circuit and my pcb are very simpler: each pad of the TPS is connected to one pin of the header. here is the link of the project: https://easyeda.com/mario.muratori86/myproject1 i have few questions: 1) since pad 12 and 13 and also 7 and 8 are connected in the TPS footprint (and that is correct, viewing TI datasheet), when i try to connect a track to it, i always get some DRC error about clearance being less than 6 mil how can i correct this? and also i would like to use a wider trace for these pads. is there a way to properly use a trace that is large 3 times one pad (3*10 mil), to connect with these pads? or maybe an area of copper ? what should i use???? 2) is it possible to receive pcb with TPS already soldered on it ??? ( i read similar question but still i dont know if it is possible) 3) is it possible to overlay a text over a trace ? 4) what is the best way to enlarge a trace starting from 10 mil, for example, to have 30 mil ???? 2 traces connected, or a copper area, or solid region? thx for any help, i really appreciate your software and want to try really your pcb service ;) #PCB#
Mario Muratori 2019-03-06 11:36:30 comment 18 0 Circuit Design