asdasdasd
GERBER FILE
hello agter generation of gerber file where can i find the gerber files ? thank you #PCB#
Maurizio Secol 2019-03-07 21:11:04 comment 3 0 Circuit Design
TRACK MISSING
Hello in design manager nets i see there are missing spme wiring but i do not find where, for istance on signal 3V3 i see that i have a cross in net design manager but on layout i do not see wire missing. how can i discover where is the missing track ? thank you #PCB#
Maurizio Secol 2019-03-07 03:40:55 comment 3 0 Circuit Design
copper area removal
hello after done copper area how do i remove it ? thankyou #PCB#
Maurizio Secol 2019-03-06 20:22:20 comment 2 0 Circuit Design
copper area removal
hello after done copper area how do i remove it ? thankyou #Schematic#
Maurizio Secol 2019-03-06 20:20:31 comment 2 0 Circuit Design
recover
is it possible to recover the pcb design of yesyerday to substitute the today layout that is not working well (see my previos post) thank you #PCB#
Maurizio Secol 2019-03-06 16:38:51 comment 1 0 Circuit Design
not trace
hello near the end of pcb the trace for gnd net disappear and i can not trace new gnd trace i start the gnd new track , vhen i click to end trace i have not the trace, Nothing. can you help me yhank you #PCB#
Maurizio Secol 2019-03-06 16:33:58 comment 2 0 Circuit Design
minimum track width and spacing
hello what is the minimum track width/spacing ? thank you #PCB#
Maurizio Secol 2019-03-04 07:31:24 comment 2 0 Circuit Design
check schemtic
hello i do not understand if it is possible to have a drc on schematic to understand if some component are not connected for wrong reason tahank you #Schematic#
Maurizio Secol 2019-03-03 17:07:03 comment 2 0 Circuit Design
max current
hello i need to know how much current can draw a track with width 1mm also i need to know how much current a vias can draw ( so with more vias i obtain the current i need) is it possible put more vias between a tgrck on bottom and on top to draw thw current i need ? if i have a big surface pin for a connector smd i can put on it some vias to go on a trck on bottom layer ? i have drc error but i think is possible ignore it. 2) i do not know how i can place component on bottom layer thank you #PCB#
Maurizio Secol 2019-03-03 17:04:48 comment 3 0 Circuit Design
component
hi i am new with easyead i was not able to find a component for MOlex connector 87437-0573 | how can i obtain it or how can i design it ? | #Schematic#
Maurizio Secol 2019-02-15 03:43:16 comment 3 0 Circuit Design
pcb shape
Hi i am new in working on easyeda my question is : is it possible to import from a dxf or other necanical drawing the shape of pcb board ? thank you very much. #PCB#
Maurizio Secol 2019-02-15 03:36:21 comment 2 0 Circuit Design