asdasdasd
Typo in "Layer Stackup" window
I've marked the typo in the image, it says "withoiut" instead of "without". #Others#
Max_H 2025-02-09 19:50:41 comment 3 0 PCB
Importance of device symbol accuracy vs readability
I've made a few changes to the device symbols in my schematic to improve readability/interpretability(?) at the cost of deviating the pin order and placement from the footprint. Is that acceptable or should I maintain the pins in the same general order and placement of the footprint? e.g.: #Schematic#
Max_H 2025-02-09 02:15:17 comment 4 0 Circuit Design
Is connecting decoupling capacitors to each other as shown good or bad?
Is connecting the ground and 3v3 lines of the (decoupling) capacitors as shown in the image good, bad or does it basically do nothing? #PCB#
Max_H 2025-02-05 05:01:08 comment 11 0 Circuit Design
What's a good (inner and outer) diameter for ground/thermal pad vias and how do I place them correctly?
Hi, I'm trying to do the layout for a tlv757(dbv). I've already connected the nets with fill regions but I'm unsure which type of via I need for the pad. The datasheet shows black dots for vias in the examples but I'm not sure exactly how big it is or how I'd derive the inner diameter when I'm only given the outer one. This is my first pcb so I'd also appreciate any other improvement tips :) #PCB#
Max_H 2025-01-28 04:08:23 comment 2 0 Circuit Design