asdasdasd
How to avoid contact of pad from bottom layer (only allow in top layer, see picture)
My track is a little bit too big (because of high current) and this one big blue track in the middle is touching the other two side pads (number 1 and 3) The thing is that I need to place a transistor in there (current arrives in bottom layer on pad number two and goes to pad number 3 in the top layer through the transistor) I need a way to make this big blue track not touch any of the side pads because the transistor leg will be in that side pads. I thought about cutting a piece of the track around the pads 1 and 3, enough for them not to touch the blue wire, but since it's a small distance I'm not sure the current will not flow through it (20amps at 220v). Any thing I could do? #GeneralDiscuss#
Mr. Spock 2021-05-25 08:05:01 comment 1 0 Others