asdasdasd
Invalid footprint
Hi Not sure where I stand on this, but I recently designed a circuit incorporating several SMD components and sent it off to JLCPCB for production. On receiving the PCBs, they did not function as expected and on closer investigation, I discovered some LCSC components had mismatching footprints. The component in question here is an N Channel MOSFET, LCSC part number C22366704 where the Drain and Source have been swapped. Here's the footprint details from EasyEDA footprint manager. Question is, who is liable for this error? Is it reasonable to expect users to check the footprint for every component being used, specifically when they are 'official' LCSC components? At the moment I am AUD80 out of pocket to JLCPCB and wondering how I can recoup this loss. Thoughts? Cheers, Mike #Library#
NomadAU 2025-05-10 04:39:40 comment 8 1 Circuit Design
Autorouter no longer working
Hi I've run into a problem with the autorouter. I'm using a local installation of the autorouter (running on Ubuntu 18.04) and when running the autorouter in local mode it appears to be hanging. However, when I look at the autorouter log file, I can see that it stops as soon as it starts, writing only the following messages. -------------Connection established----------- Start routing... Routing -------------Connection closed--------------- I don't know what has caused this, but it was working perfectly ok only a short time ago, running and completing the routes in a matter of seconds. I added a few text labels to the PCB and then it failed...removing these has not fixed the problem. I did notice earlier that it seemed to be failing if I had the Real-time Display option checked on the Auto Router Config screen, then it worked ok when this was unchecked. Maybe that is just coincidental but it might be significant in diagnosing what's going wrong here. BTW, it times out due to lack of resources if I use the cloud option - this doesn't really shed much light on the issue because I'm guessing it could fail for different reasons and still give that message? Has anyone else hit this problem and fixed it? Cheers, Mike #PCB#
NomadAU 2020-05-07 03:17:16 comment 3 0 Circuit Design
Can I simulate an opto-coupler?
Hi, I'm still cutting my teeth on EasyEDA so this might be a real newbie question...but here goes. I'm trying to simulate a relatively complex circuit comprising multiplexers and opto-couplers. This was not behaving as I expected it to, so I thought I'd try testing one component at a time, starting with a single opto-coupler. I created a simple schematic containing a single TLP175A opto-coupler and connected its 'switching' terminal to a +5V supply. I connected a 25V supply to the device's input and since the TLP175A is switched on I expected to see 25V on its output terminal. However, I get 0V, i.e. the TLP175A doesn't appear to be turning on. What I believe should happen is the following. Set the input to 0V, TLP175A output should also be 0V Set the input to +5V, TLP175A output should be +25V Any ideas on what is going on here? Is it my schematic, or is there an issue with the simulator not handling the TLP175A device? Any feedback is most welcome. #Simulation#
NomadAU 2018-06-29 04:05:45 comment 19 0 Circuit Design