How to put pin headers instead of actual component.
Hello. I want to make a PCB with female pin headers for some components (like NodeMCU board, DS3231 clock MODULE (and not just the chip), etc.). To make the electronics schematic correct, it seems I should include the actual components in my design, so I have the nets and the pin numbers and routing etc. But when sending the PCB to JLCPCB, and want assembly also - I want it to include female pin headers in the correct places and distances to be ready for me to put into them the modules. How can I 'tell' EasyEDA to make schematic of real components, but PCB with other components (pin headers) in the correct places? Thank you and all the best! #Schematic#
EasyEDA doesn't like me.. :-)
Hello, clever guys. I'm trying to build my first PCB and send it to JLCPCB for fabrication. I thought it should be the mose easy thing to do, because for my fiest PCB I'm just planning use ready-made modules (DS3231 module, NodeMCU module, and RS485 module) which I already have, and just make female pin headers for them so I'll just have to solder the 'sockets' and to put the modules into them. So I made my schema, and just wanted to go to the PCB to be able to place the headers. And then I'm starting to get error messages about checking nets, and pins don't fit pads (which I think are for pins I don't need and I didn't connect..) Can anyone please help me make this accomplished? Many thanks! #PCB#