asdasdasd
Placement of holes
Hi everyone. When I have a PCB with let's say a 4 mm. hole i every corner and i want these holes to be placed withe the excact same distance from eachother... Is there a smart way to let EasyEDA do this job... where I can write in the distance and then the holes will be placed correctly? Thank you. #PCB#
Ovemand 2025-05-20 20:58:12 comment 3 0 Circuit Design
Navigate in EasyEDA
Hello. Is there any other way to navigate around in the schematic or PCB window other than zooming in and out all the time moving the cursor and then do it again...? #Schematic#
Ovemand 2025-03-09 20:57:27 comment 4 0 Circuit Design
Power supply for multiple gates
I have a schematic with 16 different logic gates (7400-7402 and so on). I defined for all the IC the VDD and GND but when I convert to PCB only some of the IC's are connected to VDD. All are connected to GND but only some are connected to VDD...? Anybody who can help...? #Schematic#
Ovemand 2023-08-27 16:51:19 comment 1 0 Circuit Design
Power supply for Logic gates
Hello. I have made a circuit where I use Logic Gates like AND, NAND, NOR etc. and when I convert this from schematic to PCB I can see that EasyEDA automaticly connects +12 volts and ground to all the IC circuits (pin 7 and pin 12) .But there is no possibility to make terminals for + and - on the PCB itself... How can I add power supply + and - to my IC circuits on PCB...? #Schematic#
Ovemand 2023-02-14 17:05:15 comment 4 0 Circuit Design
How to change type of project
Hi everybody I have made a project when my EasyEDA was in Offline mode... Is there any way to copy my project or move it to Online mode...? When I change EasyEDA mode it have to restart and therefore I can´t just copy my project. Please help... regards Ove #Extension#
Ovemand 2022-11-08 17:18:03 comment 2 0 API & Extension
Change component in schematic without new pcb
Hello I have made a schematic with a lot of components and this is converted to a PCB and I have made a nice PCB layout. Now I have replaced one single component type in the schematic and now my question is.... do I have to converte the new schematic again and make a complete new PCB layout again for this one replacement of components...? Or is there an easdier trick...? Best regards Ove #PCB#
Ovemand 2022-06-03 18:17:27 comment 0 0 Circuit Design
Change component in schematic without new pcb
Hello I have made a schematic with a lot of components and this is converted to a PCB and I have made a nice PCB layout. Now I have replaced one single component type in the schematic and now my question is.... do I have to converte the new schematic again and make a complete new PCB layout again for this one replacement of components...? Or is there an easdier trick...? Best regards Ove #PCB#
Ovemand 2022-06-03 18:17:26 comment 2 0 Circuit Design
Copper area
Hello I try to use the "Copper area" on my PCB layout and I have followed the instruktions and after marking the square area where I want the copper area to be I rightclick and I can see that the program calculate and after finish there is nothing ti see on my PCB. What can I have done wrongly...? Regards Ove #PCB#
Ovemand 2022-03-31 16:12:48 comment 3 0 Circuit Design