Ratlines within a footprint
I am really confused and struggling to fix this problem. I have an edge connector. The footprint was the mirror image of what I wanted so I went into the footprint editor and manually swapped the pad names. Somehow, EasyEDA's PCB editor thinks that there is a connection between the pad 6th from the right and 6th from the left. The pad on the right's "Number" is 5. The pad on the left is "Number" 18. Why are they showing as connected? How can I get rid of this connection? Each pad has a different Net name - they should not be connected together. #PCB#
FPGA Placement on Schematic
When looking or a complex component such as an EP4CE6E22C8 FPGA, is there a way to select all parts of the component? It looks as though I can only select one piece (bank?) of the component at once: #Schematic#
Tips on Layout for Routing
I have looked on the tutorial on this website and Youtube but I cannot seem to find a good guide on how to layout components in such a way that auto routing will be successful. I have tried both cloud and local router methods for autorouting but figured they probably use the same algorithms.. so I installed FreeRouting. FreeRouting is now onto its 53rd pass and it is still struggling to route my design. I don't know whether it will be successful after 24 hours or not. I have tried to place components on my board so that the header connectors work for me but I am wondering if there is something fundamentally wrong with my component placement? Can somebody please recommend a good resource or set of tips for placing ICs on a board? I have made slightly simpler boards with DipTrace in the past - that always did the autorouting for me without any troubles. I tried using EasyEDA this time as I thought it would be the best choice if I want to have my boards assembled with JLCPCB. #PCB#
The netlabel is not connected with any pin
Help! I have loads of these errors and I cannot see what the problem is. Here is one example: SW2 is connected to both my pushbutton and the 2 FPGA header symbols I have created. What have I done wrong? #Schematic#
Footprint - not including all pins
I am trying to make a footprint for a 32x2 2.54" header. I thought I would start by using a 20x2 header footprint that already existed. There is still a blue rectangle in the middle of my footprint from the 20x2 design. What should I be looking for/at to change this blue rectangle so that it encompassed all of my 32x2 design? Sorry - I tried following a (very fast!) YouTube tutorial but it was for an older edition of EasyEDA standard and seemed to be missing a few important details. #PCB#