Best way of connecting array of 1mmx1mm pads to a ground plane?
I want to use a Recom RPM5.0-1.0 DC/DC converter. Its footprint is a 5x5 array of 1x1mm square pads (see below). I have no experience of devices with this kind of footprint. It seems the green pads should all be connected to the ground plane (which is on the other side of the PCB) for thermal reasons. What's the best way of doing this? I'm assuming it would be a bad idea to make the pads into small vias (I don't think I can create square vias anyway). Should one just run a narrow trace between all the green pads and bring it out beside the device where vias could go to the ground plane? If so, what trace width would you suggest? Or should one revise the footprint to block up the green pads into one piece of copper (I'm thinking that might undermine the self-locating behaviour of such arrays as the solder melts)? #PCB#
Remove clearance between copper area and pad?
Although the copper area and square pad are both in net GND, there is clearance of some kind at its corners. Likewise on the lower pads of the two capacitors. Is there a way to remove that clearance, without removing the clearance between the copper area and other things that are not in the same net? #PCB#
DRC doesn't like holes through copper?
Using the Hole tool I added two holes in opposite corners of my first PCB. One of them happened to go straight through a ground plane (Copper Area) having net name GND. That gave a DRC error saying the hole is too close to the ground plane and not of the same net name. There seems to be no way one can give a Hole a net name. So I deleted the hole and inserted a pad of the same size, giving it net name GND. That was ok. But I was just surprised that it wouldn't let me drill a hole straight through a ground plane. #PCB#
Clarity needed on "keep out" areas within Solid Region copper pour
Existing advice is unclear and conflicting. I want to pour copper into a Solid Region, but within that region there are rectangles where copper must not go. The forum suggestion is to create additional Solid Regions for those rectangles where copper is to be excluded, and to set them to type Board Cutout. If I do this, the photoview and 3D view show a hole right through the whole board. I don't want a hole; I only want to keep the copper out of the area on the specified layer. Alternatively, if I set the exclusion rectangles to type No Solid, it has no effect on the copper pour done by the enclosing Solid Region, at least as shown by photoview and 3d view. What is the correct technique please? (I am hoping it does not involve multiple Solid Regions navigating around my "keep out" areas.) #PCB#