asdasdasd
Double sided PCB won't print even if both top and bottom layers are exported?
Hi all, I'm not sure if I'm missing a step here somewhere but I am trying to print out a double sided PCB and although I am selecting, full graphics, separated layers, both top & bottom layers, when exporting to PDF I get two pages but only top layer, I can't seem to figure out / why the bottom layer will not export to pdf. The layer Mgr shows 2 layers selected. I'm using easyeda std, V6.5.22, Any help appreciated. Thanks #PCB#
Peter Costanza 2023-01-28 21:45:03 comment 12 0 Circuit Design
Unable to Export PDF
Hi, not sure if this is a bug but I've done a few boards in the past without having any exporting issue but now a new board and the PDF's are just blank even tho the file shows content. I'm using the online editor V6.4.7 and tried on two different PC's W10 and Win7, Edge and Chrome browsers...same results. Not sure what's going on here.. #BugReports#
Peter Costanza 2020-10-26 11:07:06 comment 3 0 Bug Reports
Adding components to PCB?
Hi, created a schematic, then the pcb but I added 2 new components to the schematic, Used "update all" but the 2 new components don't show up in the PCB. Do I need to re-create a new PCB for them to show up or is there some way to bypass as I don't really want to mess with recreating the PCB dimensions. BTW, when updating all in PCB it shows: update succuss! instead of success! #PCB#
Peter Costanza 2020-01-02 20:45:41 comment 2 0 Circuit Design
Autorouter - completing traces manually?
So after having numerous alignment issue trying double sided DIY PCB, I decided to try single sided (bottom layer). Autorouter completes to 93%, I'm left with a few traces to connect manually so, I added pads close to the ratlines then tried to route them manually but this doesn't seem to work. Can this be done by adding pads or vias to complete the ratlines then using jumpers on top layer? or is there some other way to go about this? thanks #PCB#
Peter Costanza 2019-12-02 02:24:55 comment 3 0 Circuit Design
Exporting more than one PCB in PDF document possible?
Hi, this is probably basic question but how do I export more than 1 pcb (same design) on the same PDF document? in other words, if my pcb is 3"x6" and I export to PDF, then I only have one PCB on the pdf document, is it not possible to fill the same pdf document to print i.e 4 PCB's? as I'm wasting alot of glossy paper or does this have to be multiplied in PCB and when exported will result in 4 PCB's? thank you #PCB#
Peter Costanza 2019-11-21 22:10:41 comment 3 0 Circuit Design
Can parts snap to grid in PCB Mode?
Hi, I'm a little new to schematic and pcb. I've designed a schematic and the components snap to grid on the canvas but when converted to PCB the components do not snap to grid anymore, its a little difficult to get everything aligned. Is there a way or just throw then and arrange as best as possible? or maybe I missed a setting? thank you #PCB#
Peter Costanza 2019-11-12 03:13:00 comment 4 0 Circuit Design