How to draw footprint for RF devices?
The recommended footprints for RF devices usually include a large number of ground vias (to reduce inductance)\, and large-area ground areas carefully placed at specific locations and distances from the pin pads. However\, most of this ground *must* be covered with soldermask so the pin pads will correctly hold solder paste. One very much wants this ground layout to be part of the footprint\, because re-drawing it every time the part is used is quite laborious and prone to accidentally making the edges of the ground a few mils off where they are supposed to be. What is the best method for drawing these pre-defined ground solid shapes? When I tried them in EASYEDA as shown for this four-pin part (which has two pins grounded\, and an input and output pin)\, I get a hundred DRC errors because there is no way to assign the metal ground areas to be net GND. Thank you. #PCB#
RebuildCopperArea should happen automatically
The RebuildCopperArea operation should happen automatically at logical points in the process. I released a board that had inner layers, and I added some new vias AFTER drawing the inner board copper areas. All of these new vias were shorted to the ground plane when I received the PCB, even though their nets were not GND. I think if I had pushed "RebuildCopperArea" for the inner layer copper areas, this would not have happened. However, since they are not the same net, it would be reasonable to make sure the software automatically Rebuilds these copper areas so the vias are not shorted. I don't know why the DRC did not catch this, but I'm quite sure I ran the DRC many times before releasing the PCB. #BugReports#