BoM Export puts all components into a single row
Hello, I'm using the EasyEDA Pro and when I try to export the BoM to CSV or XLSX all the components are being put into a single row which makes it completely useless. Why is this happening? #Schematic#
Joining nets without using a 0ohm resistor
Hello, Most of the PCBs I design are for Audio devices where management of the audio signal zero-volt reference and GND need to be carefully separated, however, at specific points these will need to be linked. Therefore having the ability to link the signal-ground net to the GND net without causing DRC errors is really important. I know this can be achieved by adding a component, such as a 0Ohms resistor works but this seems a bit a pointless. I also know this has been raised in the past as I found several other posts but couldn't find if this feature is now available in EasyEDS std? #PCB#