asdasdasd
Default Canvas Catagories
Hello, It would be very helpful if we could save our prefered canvas setup and have it used for all future PCBs. For example, when I start a new PCB, I change the units from mm to inches, and the secondary snap from 0.005 inches to 0.05 inches. I have to do this every time. And one of my PCBs had a pin that needed to be marked with the Greek letter Phi (ϕ), which the Default font doesn't support, so I have to use an imported font. I'd like to make that font the default font on my PCBs so that not only text gets added in that font, but when a component gets added to the board, its lettering is in that font. While I haven't changed any setting on the schematics canvas, I can see this feature being a big help there as well. Thank you, Rick #FeatureRequests#
Rick Seiden 2019-11-13 12:54:17 comment 2 0 Feature Requests
Default settings for PCB Canvas
Hello, Is there any way to set default properties for any new PCB's I make? For example, when I create an new PCB from a schematic, it starts out in mm, and I want it in inches. Once I switch it, the snap is 0.005 inches, and I want it at 0.05 inches. Then the font is the default font for everything, and I have a font that I'd rather use for everything. Thanks, Rick #Skill#
Rick Seiden 2019-11-11 18:51:46 comment 3 0 Circuit Design