asdasdasd
Gold wire bonding pads
Hi all! I am drawing my first PCB for the use as a carrier board for a gas sensor. I work in gas sensor development. The gas sensor is a stack of heater, thermoelement and a metal oxide layer on top of a silicon substrate. The silicon substrate onto which the metal oxide layer is deposited contains an electrode system. The electrodes are connected to bond pads. On the PCB I have drawn corresponding wire bond pads (solid areas) which are connected to male header pins. My question is, what layer should i define the solid areas so that these areas are the top layer and can be used as wire bond pads? If my description is not up to your standard, I am sorry and I will revise :-). Thanks in advance! Best regards Robert #PCB#
Robert Wimmer-Teuben 2020-11-13 09:09:56 comment 1 0 Circuit Design