how to make a round board with a v-cut
Hello. Tell me how to make a round board with a v-cut cutout (so that it can then be simply broken off). I have two double-sided boards made from one circuit, round. If I use "Panelize" then it just makes a rectangle with two round areas. jlcpcb sees them as a single board rectangular Здравствуйте. Подскажите, как сделать круглую плату с вырезом v-cut (чтобы ее потом можно было просто отломить). У меня из одной схемы сделанно две двухсторонние платы, круглые. Если я использую "Panelize" то он просто делает прямоугольник с двумя круглыми областями. jlcpcb видит их как одну плату прямоугольную #GeneralDiscuss#
The connection of two round boards
Along the perimeter of the two round boards, there should be holes corresponding to both boards, so that they can be connected through these holes only in one position, as well as these holes on each board have their own paths. Is it possible to automatically place these holes? По периметру двух круглых плат, должны быть расположены отверстия, соответствующие обеим платам, так что бы их можно было соединить через эти отверстия только в одном положении, так же к этим отверстиям на каждой плате идут свои дорожки. Можно как то автоматически разместить эти отверстия? #PCB#