Voltage drop on graetz
Hi all, I need clarification about Graetz bridge because reading several books and web pages and doing a simulation in EasyEda I have different results. I am starting a few projects on EasyEda just to test my old Electronic knowledge and start again an old passion. I am trying to build a simple Power supply step by step to test my knowledge but also EasyEda. I created this project for a 230V AC (50Hz):12V AC using a transformer of 0.053 ratios. So far so good. I have a 12.115V AC in output and almost 17 Vp and 34 Vpp. The load is a 10k Resistor. https://easyeda.com/sasadangelo/transformer In this other project, I added a Graetz Bridge and I expect to find my 17Vp dropped of 1.4V (due to two diode of the bridge). So I expect to have 17-1.4=15.6Vp (15,6*2=31,2Vpp) and then (15.6Vpp/1.41)=11.06. https://easyeda.com/sasadangelo/powersupplywithcapacitor From the simulation, I see Vp=16.3 and Vrms=11.49 in a multimeter. Around the web and books I find three design approaches that bring to a different result: 1) Now, some books report that Vp=(12V-1.4)1.41 but I think THIS FORMULA IS WRONG because the voltage drop is applied to the sinusoidal wave, not the RMS one. 2) Other resources, report Vp=12V1.41-1.4=15.52V, and this value does not agree with EasyEda. 3) I found other resources like this: https://electronics.stackexchange.com/questions/229381/output-voltage-calculation-for-full-wave-bridge-rectifier that apply the 1.4 drops to Vpp instead of Vp and this kind of resource seems in agreement with EasyEda. However, applying logic to me it seems that 2) should be the correct one. In fact, when a positive semi wave crosses the bridge it passes through two diodes, so the positive semi wave should have a drop of 1.4V, the same for the negative (while EasyEda according to 2 has only 0.7 drops). Can someone help me to understand why EasyEda and this resource are correct? #Simulation#
How to add a diode Zener?
Hi Everyone, I am new to EasyEda and I started to do some simple circuits. I want to try a simple 12 V Diode Zener circuit with a Zener and two Resistors and 15 V DC source. Here the circuit: https://easyeda.com/sasadangelo/simplezener The problem is that I don't find it in EELib. I searched in SpiceLib but when I add to the schema and start the simulation it says that it is not in EELib. I noticed there are a lot of people use Zener in their schema, how I can do it? How I can use Diode Zener with common voltage 2.4, 4.7, and so on? Another thing I want to do is check the output voltage when the output resistor value increase or decrease, to do that I want to use a vbProve but it's not clear to me where to find the voltage value. Thank you in advance for your help. #Simulation#