asdasdasd
Unclear Order of Inner Layers
It is unclear whether "layer 1" or "layer 2" is the closer one to the "bottom" layer. This can be very important when considering inductive and capacitive coupling between tracks/planes. It is not possible to visually determine the order of the inner layers by crisscrossing tracks in the software as the layering order seems to change depending on the selected layer. Advice? #GeneralDiscuss#
Shant Centistoke 2021-01-09 22:19:25 comment 2 0 Others
New Footprint NOT registering
Very tired of this. For whatever reason, when I try to create a new component (symbol and footprint), sometimes the footprint assignment tool within the symbol page can not find the footprint I have created. Usually, the footprint appears in my search within seconds. But sometimes, it claims that it does not exist when in fact I can see the saved file in my list of user contributed footprints. I try deleting the file and recreating it, it does not work. I try waiting for the server to update, it does not work. #BugReports#
Shant Centistoke 2021-01-08 19:10:35 comment 19 0 Bug Reports
Copper area not filling all the way
The copper area tool is not filling up the entire outlined area. There are no obstructions. It always seems to be the right hand side of any area I outline and fill. A vertical strip along the right side of any copper area will not fill. #BugReports#
Shant Centistoke 2021-01-02 10:07:09 comment 2 0 Bug Reports
Scrolling Difficulty
Is there a way to scroll vertically as easily as scrolling horizontally? The CAD makes it very easy to scroll horizontally by dragging left or right. But scrolling vertically requires zooming out from a particular point, then zooming back in from another point. This wastes so much time. #GeneralDiscuss#
Shant Centistoke 2020-10-16 18:15:35 comment 4 0 Others
Copper Area (copper plane) not registering vias and pads
The copper area tool has two issues I have not been able to work around. 1- (less critical) Its very annoying that the CAD does not form a copper area in which there is less than 2 pads or vias. This is very annoying when you need to create a guard plane (on the inner or outer layers) with one node of contact such as one via or one pad for the entire copper plane. 2- Sometimes the Copper Area tool does not register that a via or pad is of a different potential and still creates a bond with it. Its very difficult to break this bond, and sometimes it DOES NOT break the bond. One must fiddle with it until it works. Such as using the "rebuild copper area" tool over and over again and changing the net names of the vias or pads in differing orders to make it recognize that it should not form a bond with it. Example: I create a ground plane and it forms bonds with ONLY the pads and vias that are set as ground in the NET. Then I add a new pad or via that is NOT ground, and rebuild copper area to exclude it from the plane. It does NOT break the bond and I must fiddle sometimes for 30 minutes, and sometimes it doesnt even work at all. Great software in general, but this particular issue weighs a lot. #BugReports#
Shant Centistoke 2020-10-16 18:11:16 comment 1 0 Bug Reports