Sticky Tracks
Here's what I've been thinking. I love the auto track feature, it's amazingly powerful. At some extent though, it creates weird tracks sometimes and after the auto-track is done, I need to reposition a few... to avoid this, I'd like a sticky track feature. IE, I manually place a track between components and want it to stay there, so I check an option it the tracks attribute sheet. Then, when running the auto-track, no matter what it tries, it needs to work around it. #FeatureRequests#
Ratlines showing unconnected routes when in fact they are
BUG Concise problem statement: On some occasions, especially after replacing components, the ratlines will show up as if the pads or the nets were not properly connected. I need to save, close the pcb and reopen and the ratlines are gone. Steps to reproduce bug: Place a component to a PCB and connect the pads to the circuit. Place a new component over top and give the pads the same net names as the underneath component. Delete the underlaying component and sometimes, ratlines will appear. I need to save my PCB and close it. When I reopen, the ratlines are gone. Expected results: Ratlines should be present only when pads are not properly connected to their respective nets. Browser: IE11 #BugReports#
Automatic 45/90 degrees when modifying traces
Basically simple, sometimes i'm moving my tracks around manually to fix DRC errors, but my angles aren't perfect. I zoom in and try to fix the angles on my tracks the best I can by removing the pixels in the line, when I see no pixels on the trace borders i'm pretty sure they are accurate 45 or 90 degrees turns. What if you added CTRL while holding the trace marker (green dot on the turning points) to force them into the setting Route Angle. Keep the ALT snap as well to pin point the marker. I don't know if that would work without destroying all the layout though! #FeatureRequests#
Add the possibility of editing a component PCB lib on the fly
Basically, sometimes I need a component, but some lines or parts of it are not necessary to me. I'd like to have a "Edit component PCB lib" option in the Edit menu that would take the component to the PCB lib editor and when I save it, instead of saving it to my parts catalog (or in addition to saving it to my parts catalog) it would automatically update the component on my PCB. Doing so would be very useful since at the moment, when I need to update a PCB lib, I need to bring up the component in the search engine, the click edit, do my updates, then save or save as, then search for the component again, then place it, the re-attribute all the pad nets... having the ability to change a little detail in my lib right from the PCB editor could save me lots of time this way! Hope i'm clear enough. Thank you! #FeatureRequests#
Align with center
Same as align to left/right/top/bottom, except this would actually align a component with the center of another. Would be helpful to center component names with the middle of the component or the correctly align various parts with other by the middle. #FeatureRequests#
Upgrade to Auto-Routing
Feature Request The Auto-Router IS a powerful tool. Make it a Super-Tool. What I mean is that it often time out generally because of the complexity of the setup and the required connections. If the parts aren't properly positioned on the PCB layout, the auto-router will more than likely time out. Here's what I suggest. Give the user the ability to lock certain parts into position, (i.e. connectors on the edges or specific parts that need to be installed precisely where the user has set them in order to match an other PCB like header connectors). All other components that have not been locked into position can be moved/rotated freely by the auto-router with the PCB boundaries set by the user. This in order to allow the router to more effectively route the tracks between components! #FeatureRequests#