asdasdasd
For a high-current connection, I'm trying to route top AND bottom - easyEDA removes one.
For a high-current connection, I'm trying to route top AND bottom to have more copper cross section. Once I finish the second track, easyEDA removes the first one. Is there a way to switch that off? (btw. is there a Hotkey to switch layers? "B" doesn't work for me in easyEDA pro). #PCB#
SteveFi 2024-02-13 23:15:05 comment 4 0 Circuit Design
Heatsink for TO220 device (for placement by JLCPCB)
I'm trying to design an PCB, where a TO220 components needs a medium sized heatsink. How can I make sure, that the position of the heatsink and the TO220 match, so that the can be attached to each other? In 3D view it looks like this: The TO220 is sitting very very low (unrealistically low) on the PCB, so the mounting holes don't align. Is there a way to either: set the right placement height of the TO220? a heatsink that will properly align? or a way to tell JLCPCB that they should be screwed together before soldering? (or any other solution?) Thanks, Stefan #Others#
SteveFi 2024-02-01 23:03:39 comment 3 0 PCB
When copying components in schematic, 3D models don't show up in 3D view
When copying components in schematic, 3D models don't show up in 3D view. 2D view seems to work as footprint is shown, but in 3D view the device model does not show up (footprint still OK, also in 3D). #PCB#
SteveFi 2024-02-01 10:12:20 comment 3 0 Circuit Design