asdasdasd
Problem with inner layers and defining them as GND and VCC
So I am trying to use the XC6SLX25-2FTG256I and a 4 pin connector with 1.2v, 2.5v 3.3v and GND. All I have done to start with is connected all the VCCO's to VCC, VCCINT to 1.2v, VCCAUX to 2.5v pins and all the GND pins to GND. As this is a BGA, I am trying a 4 layer board. I wanted to put VCC and GND on the inner two layers. Firstly I set the two layers as PLANE and changed their names to VCC and GND. Ran Autoroute and it did not connect anthing to the inner layers and also failed to route. I then changed the innerlayers to Signal and created a copper layer on both and correctly named VCC and GND. Ran autoroute and again, did not connect the VCC and GND pins to these layers. Clearly I am missing the obvious so if anyone has done this before, please could you point me in the right direction. Thanks in advance #PCB#
Telboy 2024-06-17 03:08:56 comment 4 0 Circuit Design