Pop-up Warning when applying copper area
I get the following warning when I attempt to apply a general copper fill to the entire board, exclusive of tracks: Warning EasyEDA does not allow inner board outlines cutout. Please use SolidRegin or HOLE. That is exactly how it appears, including the misspelled word ( I'm pretty sure it's meant to say "solid region"), but I don't know what it means, or how to fix the issue. I am not even sure if I'm asking for outlines to be cut out. Using a solid region instead of copper area obliterates all tracks, so no. I could apparently fix the problem with a hole, but it is not obvious to me where the hole should be placed. I was actually trying to avoid holes other than the ones for the pinheader. Any solution for this available? Thank you in advance for your time and expertise. Thermas #PCB#