asdasdasd
Fixing auto routing / sharing project
This is my first ever attempt at creating a PCB. I'm in the process of converting DMX light fixtures that traditionally require 3 pin XLR cables to a wireless endpoint running firmware on a Wemos D1 mini. I have 1 issue and 1 question: Issue: The router (installed the local router) complains of 1 error. Based on the advice of another user on this forum I was able to locate the ratline. The issue is the 5V power connection that's missing from the incoming power socket CN1 to 5V on the D1 mini U1. I think I somehow go from the toplayer to the bottomlayer but I can't figure out how to do it. Question: I use my own resistors rather than SMD type resistors and therefore have to create holes that are still connected to the signal line. I think the Pad(P) is the correct wiring tool. I simply dropped it onto the signal line and it seems to be connected allowing me to create the spacing I need. Are pads holes in the board? Is there a smarter way to pick up these types of resistors right from the library during the development of the schematic? I understand I can make projects public for review by others. I'd be happy to do that if that helps in pointing to the error/tips #PCB#
Thomas Meier 2021-07-31 01:50:03 comment 11 0 Circuit Design
Auto route error
I try my first PCB design. During the routing I get the following output: Attempted 54, completed 54, failed 1. However other than the popup there doesn't seem to be any guidance which connection failed. How do I track the error? #PCB#
Thomas Meier 2021-07-30 13:53:22 comment 7 0 Circuit Design