asdasdasd
soldering issue of Inductors 0402DF
Hi everyone, I was trying to solder this inductor onto a PCB board made by JLCPCB, but it is very difficult to get it soldered. The other parts are easy to solder. I noticed that it is a Ferrite Chip, which should be a different materials from other parts. Does someone know how to solder this inductor? Thank you! #Skill#
Yanwei Xiong 2019-06-29 00:00:10 comment 6 0 Circuit Design
design a PCB 3GHz phase shifter
Hi everyone! I am new to PCB design. I need to design a simple PCB board for a 3GHz signal phase shifter (HMC928LP5E). This phase shifter evaluation board has been obsolete, but I ordered a few chips and try to make a board myself. The issue I have is that the signal lines, RFin and RFout, need to have 50 ohm impedance. I looked some impedance calculator online, like this one, https://www.multi-circuit-boards.eu/en/pcb-design-aid/impedance-calculation.html. By doing so, I need to change a few parameters, like track height, isolation height etc, to make the impedance to be 50 ohm. I noticed that it is easy to change trace width with EasyEDA, but how to change the other parameters, like trace height and isolation height? Thank you! #Skill#
Yanwei Xiong 2019-05-04 00:12:11 comment 8 0 Circuit Design