asdasdasd
Getting a TL072 LTSpice subckt to work
Hi, I'm reading up on the tutorial of spice simulation and I'm at the part where it is explained how to use an external LTSpice model. I try to repeat the steps in the tutorial for a TL072 op amp. https://oshwlab.com/Zoldar71/create-spice-model-of-tl072 When running the simulation I get the following error 'The circuit has components without simulation model: dx'. I pasted the AD817 spice model text from the tutorial example in the schema and changed the op amp symbol name to AD817. Now the simulation runs fine. I can see that the TL072 subckt uses a dx model, but the AD817 subckt also uses a dx model. What am I overlooking? Cheers, Martin #Simulation#
Zoldar71 2021-01-22 16:41:36 comment 7 0 Circuit Design
Ammeter not in the system library
Hi I read up on the spice simulation tutorial and there was a nice article about probing. In this article I found you can use an ammeter to probe voltages. I could not find it in the standard EELib. I did find a lot of them in the user contributions section. In the simulation article it also is mentioned to avoid user contributed models. So which one to use? I see that Andy Fierman uploaded an Ammeter. Should I use that one? Same question for the Diff_V_Probe. Cheers, Martin #Simulation#
Zoldar71 2021-01-20 02:31:16 comment 3 0 Circuit Design
Spice commands in my schema after simulation
Hi, When I run a simulation the spice simulation commands apear in the schema in a very large font. I searched the forum up and down but couldn't find if there was a way to turn this feature of or maybe change the font somewhat. Maybe you guys can help me out. I use the online version of EasyEda. Cheers, Martin #Simulation#
Zoldar71 2021-01-17 22:06:34 comment 5 0 Circuit Design