LM317 voltage drop problem in constant current configuration
Hello peeps, I have been working on a 10mA constant cource that supplies atleast 5V at output. I have been using the LM317 regulator for creating the constant current source of 10mA but the voltage drop is too high. I read in the datasheet of LM317 that it has a 1.25V drop. I have been using a 9V DC input. I have attached the datasheet for LM317, the spice models I have created as well for your reference. It would be great if anyone could help me sort out the problem. I need to arrive at a circuit that outputs 5V at 10mA. Any help and comments are appreciated much. Thank youLM317 Datasheet #Simulation#
Simulating the positive temperature co-efficient using resistances
Hello peeps, I am currently working on a circuit that can simulate the function of KTY81-110 temperature sensor using resistances. The value of resistances have been obtained from the datasheet of the sensor for three diffrenent temperatures. The input is derived from a DC-DC converter and the value is 9V, 111mA. I am trying to use a constant current diode (S-102T) to maintain the current at 1mA before deriving the output from the circuit. I am consfused with the placement of the CRD in the circuit. I am still a beginner with simulating sensors. So any advice, comments or flaws in this design is welcome. Thank you people :) #Schematic#
Connection tester schema error?
Hello fellow enthusiasts, I have been developing a PCB to test the continuity of connections between two components at different parts of a machine using 4013 and 4017 ICs. It seems that the PCB doesn't function. A previous PCB with lesser number of connections functioned like a wonder. It would be great if any of you could help or guide me towards the error. I have attached the project link. Let me know if any more data is required. https://easyeda.com/ajay.chakkaravarthy/continuity-tester-sps #Schematic#
Advice required for continuity tester circuit
Hello guys, I am working on a continuity tester PCB to test the connectivity between terminal blocks and to eliminate cross connection. I have designed a circuit using 555 timer and 4017 counter ICs. The circuit has two parts. One to check the connections for a 10-10 pin cable system and the other for a 24-24 pin cable system. I problem lies in the 24 to 24 pin testing connection. The problem is the 1st and the 11th leds light at the same time. Normally, the 11th LED should go on after the 10th. I have attached the schematic. Any help would be appreciated. Thank you. #Schematic#