asdasdasd
Please verify my AC driver circuit using OPTO & TRIAC
Hi As I've introduced myself in the previous post, I am quite new at this. I have some experience with using relays to drive an AC load, but here I want to not use 5V or 12V altogether. So I recently discovered that I could use an optotriac + triac combo to drive a load like a relay. I need someone who has more experience to teach me if I've done something wrong here and if so, what did I miss? GPIO signal is a 0/3.3V signal. This is to drive an inductive/resistive load. (I built this circuit using a breadboard without the AC connected. With a multimeter on the AC pads, I measured infinite ohms when GPIO is low and about 12 MOhms when GPIO is high. I am expecting 0 ohms when GPIO is high, like a relay would - but as I understand the triac resistance depends on the current going through. Anyway, I am not confident with this circuit because of this) Thank you in advance! #GeneralDiscuss#
aledrus 2021-03-23 23:01:05 comment 17 0 Others
Finding a mains (VAC) pad
Hi everyone. I'm new here. This is going to be my first PCB. I have almost finished a design, but I want to connect AC mains to the board. Here I don't know what to do. I searched the forums and people suggest adding pads instead of connectors with barriers. To be honest I don't know what is the industry standard, I'm just a hobbyist. So I want to add a pad/connection for Live and another for Neutral, they will go to my 240->3V3 buck converter. What do I need to search for in the library to find AC pads? I've searched the library but the ones I've found seemed small or maybe that's enough. Secondly, how do I determine the distance/clearance between the pads? Do I need to keep the same clearance for the AC lines as well? Thanks in advance. #PCB#
aledrus 2021-03-17 20:22:36 comment 6 0 Circuit Design